Toro 60213 60216 Operator's Manual page 43

Figure 64
1. Engine deck
2. Clutch roller
6. If the measured air gap is not within the specified
range, adjust the gap as follows:
A. Move the clutch lever to the O
B. Loosen the nuts and bolts that secure the
engine to the engine deck
Figure 65
1. Idler pulley
2. Setscrew
C. Move the engine position as follows:
•
Increase the air gap—move the engine
away from the idler pulley
•
Decrease the air gap—move the
engine toward the idler pulley
65).
D. Align a straightedge across the engine
pulley and the idler pulley
g019976
3. Clutch air gap: 2.5 to 6.5
mm (3/32 to 1/4 inch)
position.
FF
(Figure 65).
g020006
3. Nut and bolt
4. Engine deck
(Figure 65).
(Figure
(Figure 66).
1. Engine pulley
2. Idler pulley
3. Reduction case (engine)
4. Belt guide
E. If necessary, pivot the engine on the engine
deck until the engine pulley and idler pulley
are aligned to the straightedge
F. Tighten the nuts and bolts that secure the
engine to the engine deck to a torque of 18
N∙m (13 ft-lb).
G. Check the air gap between the engine deck
and the roller on the clutch. If the air gap is
not within the specified range, repeat step
until the air gap measurement is within the
specified range.
H. Install the divider plate; refer to
the Divider Plate (page
Important:
Ensure that the paddles do not rotate
when the clutch lever is in the O
43
Figure 66
5. Idler shaft
6. Jam nut
7. Setscrew
8. Straightedge
(Figure
Installing
28).
position.
FF
g020009
66).
6