Toro 60213 60216 Operator's Manual page 41

7. Remove the oil-level-check bolt and washer
from the oil-level port
•
If the oil level is below the threads in the
oil-level port, add oil as follows:
A. Remove the filler bolt and washer from
the filler port on the top of the reduction
case (Figure
B. Slowly pour the specified oil into the fill
port until the oil level is level with the
threads at the bottom of the oil-level
port.
C. Install the filler bolt and the washer to
the filler port of the reduction case, and
tighten the filler bolt
•
If the oil level is too high, allow the oil to flow
out until it is flush with the threads at the
bottom of the oil-level port.
8. When the oil is level is flush with the threads
at the bottom of the oil-level port, install the
oil-level-check bolt and washer to the port, and
tighten the bolt (Figure
9. Install the divider plate; refer to
the Spark-Plug Wire (page
Changing the Reduction-Case Oil
Service Interval: After the first 20 hours—Change
the reduction-case oil.
Every 100 hours/Every 6 months (whichever
comes first)—Change the reduction-case oil.
1. Park the machine on a level surface and shut
off the engine.
2. Allow the engine to cool.
3. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
4. Remove the engine; refer to
Engine (page 36).
5. Drain the fuel tank; refer to
Tank (page 39).
6. Remove the filler bolt and washer from the filler
port on the top of the reduction case
(Figure 61).
61).
(Figure 61).
61).
Disconnecting
28).
28).
Removing the
Draining the Fuel
(Figure
1. Oil-level-check
bolt
2. Washer
7. Remove the oil-level-check bolt and washer
from the oil-level port in the side of the reduction
case (Figure
8. Align a drain pan to the hinge of the engine deck
(Figure 63).
9. Rotate the engine on the hinge side of the
62). engine deck, and drain the oil from the reduction
case (Figure
10. Carefully lower the engine and engine deck.
11. Slowly pour the specified oil into the fill port
until the oil level is level with the threads at the
bottom of the oil-level port
12. Install the oil-level-check bolt and washer to the
oil-level port of the reduction case, and tighten
the bolt (Figure
41
Figure 62
3. Oil-level port 5. Filler port
4. Pulley 6. Filler bolt
62).
Figure 63
63).
(Figure 61).
62).
g020127
g020128