Advertisement
Problem
The processor will not operate.
Blender or mill will not operate
Processor stops during
processing
Blender or mini chopper/mill leaking from
blade assembly base.
Poor performance of tools/attachments
troubleshooting guide
Cause
No Power.
Bowl not fitted to power unit correctly.
Bowl lid not locked on correctly.
Blender or mill not locked on correctly.
Blender or mill not assembled correctly.
Processor overloaded/maximum capacities
exceeded.
Lid unlocked.
Seal missing
Seal incorrectly fitted
Seal damaged.
Refer to hints in relevant "using the attachment" section. Check attachments are
assembled correctly.
9
Solution
Check processor is plugged in.
Check bowl is located correctly and
the handle is situated towards the
right front hand corner.
Check that the lid interlock is
located correctly into the handle
area.
The processor will not work
if the bowl and lid are fitted
incorrectly.
If none of the above check the
fuse/circuit breaker in your home.
The blender or mill will not operate
if fitted incorrectly to the interlock.
Check blade assembly is fully
tightened into the goblet/jar.
Check maximum capacities stated
in the recommended speed chart.
Check lid is locked correctly.
Check seal is fitted correctly and not
damaged. To obtain a replacement
seal see "service and customer care".
Advertisement
