Table of Contents
Advertisement
Installation and connection
en
Transportation
Preparatory work
Turn off the tap.
1.
Release the water pressure in the
2.
supply hose.
Filter in the water inlet hose blocked
~ Page 44
Drain any residual washing water.
3.
Drain pump blocked ~ Page 43
Disconnect the washer dryer from
4.
the power supply.
Remove the hoses.
5.
Installing transportation protection
devices:
Remove the covers and keep in a
1.
safe place.
If required, use a screwdriver.
Insert all 4 sleeves.
2.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
Always remove the transportation
■
protection devices!
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the Spin or
Drain programme.
20
Advertisement
Table of Contents
