Installing & Cleaning Cartridge Filter - Vacmaster VBV809PF Operator's Manual

Wet/dry vacuums
Hide thumbs Also See for VBV809PF:
Table of Contents

Advertisement

1. Verify that the power cord is disconnected from the outlet.
2. Remove the four screws holding the intake shield and lift off the shield (Fig. 2).
3. Remove the foam pad from the blower and clean the foam pad with soapy water and allow to
dry (Fig. 3).
4. Check the foam pad for reuse. If you need to replace the foam pad consult the parts list of the
manual.
5. Replace the foam pad onto the blower aligning the holes to the screw tabs (Fig. 4).
6. Reinstall the intake shield and the four screws (Fig. 5).
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The accessories
should be cleaned and stored so they can be readily available when needed. Store the wet/dry
vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using
only identical replacement parts.
INSTALLING & CLEANING CARTRIDGE FILTER
1
2
INSTALLING CARTRIDGE FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the power head and place in an upside down position.
3. Install the cartridge filter over the filter cage making sure the cage is completely covered (Fig. 2
& 3).
4. Place the filter retainer on the top of the cartridge filter over the raised lip and tighten down by
turning the retainer clockwise; do not over-tighten (Fig. 4 & 5).
5. Place the power head back onto the collection tank.
REMOVING & CLEANING CARTRIDGE FILTER
1. Unlock and remove the filter retainer by turning the retainer handle counter clockwise.
2. With the removed power head in an upside down position, carefully remove the cartridge filter
from the filter cage (Fig. 6).
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new filter is recommended.
4. Install cleaned or new filters as above in steps 2-4 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter
cage.
3
4
o
13
6
5

Advertisement

Table of Contents
loading

Table of Contents