Optoma ZU550T User Manual page 8

Table of Contents

Safety notice

WXGA

WARNING

- This product is classified as Class 3R of IEC 60825-1 : 2007 and also complies with 21 CFR 1040.10 and

1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007. IEC 60825-1:2014: CLASS

1 LASER PRODUCT - RISK GROUP 2

- Explanatory label is shown all information of laser power.

- This projector has built-in Class 4 laser module. Disassembly or modification is very dangerous and should never

be attempted.

- Any operation or adjustment not specifically instructed by the user's guide creates the risk of hazardous laser

radiation exposure.

- Do not open or disassemble the projector as this may cause damage by the exposure of laser radiation.

- Do not stare into beam when the projector is on. The bright light may result in permanent eye damage.

- When turning on the projector, make sure no one within projection range is looking at the lens.

- Without following the control, adjustment or operation procedure may cause damage by the exposure of laser

radiation.

- Adequate instructions for assembly, operation, and maintenance, including clear warnings concerning precau-

tions to avoid possible exposure to laser and collateral radiation in excess of the accessible emission limits in

Class 3R.

- This projector is a Class 3R laser device that conforms with IEC 60825-1:2007 and CFR 1040.10 and 1040.11.

- Class 3R laser product, Do Not Stare Into Beam.