Table of Contents
Advertisement
APPENDICES
Projector Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnect-
`
ing power.
Check that "Keypad Lock" is not activated by trying to control the projector with the remote control.
`
If the remote control does not work
Check if the operating angle of the remote control is within ±30° both
`
horizontally and vertically on one of the IR receivers on the projector.
Make sure there is no obstruction between the remote control and the projector. Move to within 12 m (±0°)
`
of the projector.
Make sure the batteries are inserted correctly.
`
Replace batteries if they are exhausted.
`
Ensure that you have set your remote to the correct IR code setting.
`
When making a direct connection from your computer to the projector
If you have network connection problem from your computer to the projector, please refer to the computer
`
setting as below or contact with web administrator.
Step 1: Find an IP Address (192.168.0.100) from LAN function of projector.
Step 2: Select "Apply" and push the "Enter" button. Once the setting is saved, exit the OSD by pushing
"Menu" button.
Step 3: To open Network Connections, click Start, click Control Panel, click Network and Internet
Connections, and then click Network Connections. Click the connection you want to configure, and
then, under Network Tasks
Step 4: On the General tab, under This connection use the following items, click Internet Protocol(TCP/
IP), and then click "Properties".
42 English
, click Change settings of this connection.
Advertisement
Table of Contents
