Configuring The Wireless Network - Kyocera 1102RV3AS0 Operation Manual

Installing and Setting up the Machine > Network Setup

Configuring the Wireless Network

When the wireless network function is available on the machine and the connection settings are configured, it is possible
to print in a wireless network (wireless LAN) environment. The configuration methods are as follows:
Configuration Method
Configuring the connection by
using WPS push button on the
*1
operation panel
Setting the connection by
using the Wi-Fi Setup Tool
Configuring connections on
*2
the Web Page
*1 Configure the settings on the operation panel if your access point supports WPS.
Command Center RX User Guide
*2 Before configuring the wireless network by using computer, connect the machine directly by using LAN cable or the wireless
connection by using Wi-Fi Direct.
Preparation before configuring the Wireless Network by Using Computer (page 2-16)
NOTE
On a model with a Wi-Fi function, change the settings in "Primary Network (Client)" appropriately if you switch to other
than a wired network interface.
Command Center RX User Guide
Configuring the Connection by Using WPS Push Button on the Operation Panel
When your access point supports WPS push button, you can configure the connection directly by pressing WPS push
button on both side.
1
2
3
4
When your access point supports WPS push button, you
can configure the connection directly by pressing WPS
push button on both side.
This is the tool included in the Product Library. You can
*2
configure the connection according to the instructions
provided by the wizard.
The connection can be set from the Command Center RX.
Enable Wi-Fi mode.
Simultaneously press the [Go] key and [Wi-Fi Direct] key on the operation panel for 10
seconds or more.
NOTE
You can also enable Wi-Fi from Command Center RX.
Configuring Connections on the Web Page (page 2-18)
Turn the machine OFF and then ON.
Power On/Off (page 2-9)
Press the WPS push button on the access point.
Press the [Wi-Fi Direct] key on the operation panel for 5
seconds.
NOTE
This operation means pressing a WPS push button.
The network between this machine and the access point configured.
Description
2-15
Reference Page
Configuring the Connection by
Using WPS Push Button on the
Operation Panel (page 2-15)
Setting the Connection by Using
the Wi-Fi Setup Tool (page 2-17)
Configuring Connections on the
Web Page (page 2-18)