Printed Image Trouble - Kyocera 1102RV3AS0 Operation Manual

Troubleshooting > Troubleshooting

Printed Image Trouble

When the following printed image trouble occurs, implement appropriate procedures.
Symptom
Printed images are totally
too light.
Printed images are too dark
even though the background
of the scanned original is
white.
Black dots appear on the
white background when
white original is scanned.
Checkpoints
Is the paper damp?
Have you changed the density?
Is the toner distributed evenly within the
toner container?
Is EcoPrint mode enabled?
Are the drum unit and developer unit
installed correctly?
—
—
—
—
—
—
Corrective Actions
Replace the paper with new paper.
Select appropriate density level.
Shake the toner container from side to
side several times.
Disable [EcoPrint] mode.
Correctly install the drum unit and
developer unit.
Make sure the paper type setting is
correct for the paper being used.
Select [Adjust print quality] in the
Maintenance menu, and select
[Refresh] in [Drum refresh].
Select [Adjust print quality] in the
Maintenance menu, and select
[Refresh] in [Drum refresh].
Select [Adjust print quality] in the
Maintenance menu and set a higher value for
"Drum charge setting". Increase the
adjustment value 1 level at a time from the
current value. If there is no improvement after
the value is increased by 1 level, increase by
1 level again. If there is no improvement,
lower in increments of 1 level from the original
setting. If there is no improvement after the
value is decreased by 1 level, decrease by 1
level again. If there is still no improvement,
return the setting to the original value.
Select [Adjust print quality] in the
Maintenance menu, and select
[Refresh] in [Drum refresh].
Select [Adjust print quality] in the
Maintenance menu and set a higher value for
"Drum charge setting". Increase the
adjustment value 1 level at a time from the
current value. If there is no improvement after
the value is increased by 1 level, increase by
1 level again. If there is still no improvement,
return the setting to the original value.
6-13
Reference
Page
page 3-2
page 4-17
page 6-6
page 4-2
page 6-2
page 4-17
page 6-10
page 6-10
page 6-10
page 6-10
page 6-10