Fujitsu P24W-7 LED Operating Manual page 27

Using the touch sensors
1 = On/Off touch sensor
2 = Power supply indicator
The colour of the LED indicator changes as follows:
LED indicator
blue
green
orange
does not light up
The "0" setting for the 0 W switch (3) on the rear activates the ECO energy-saving mode
(0 W operating mode); the "I" switch setting switches to BASIC energy-saving mode
(<1 W). This setting is only required for the DisplayPort cable, but it can also be required
for VGA or DVI on many PCs if the screen stays dark in 0 W operating mode.
► Switch the device on using the ON/OFF button (1) or the ON/OFF touch sensor (1).
Fujitsu
1
2
Status
Monitor and computer are switched on (normal mode).
Monitor and computer are switched on (ECO mode).
Monitor is not receiving a video signal or is in BASIC power saving
mode.
Monitor is switched off (or is in 0 W energy-saving mode).
3
3 = 0 W switch (on the rear of the monitor)
Operation
1 2 3
23