Connecting Your The Display - Iiyama ProLite LE6540UHS-B1 User Manual

CONNECTING YOUR THE DISPLAY

Ensure that both the computer and the display are switched off.
Connect the computer to the display with the signal cable.
Connect the computer with the RS-232C Cable from the Display.
C onnect the Power Cable to the display first and then to the power supply.
T urn on your display (Main Power Switch and Power Switch) and computer.
 The signal cables used for connecting the computer and display may vary with the
NOTE
type of computer used. An incorrect connection may cause serious damage to both
the display and the computer. The cable supplied with the display is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
 Make sure you tighten the finger screws at each end of the Signal Cable.
[Example of Connection]
Power Cable (Accessory)
HDMI Cable (Not Included)
GAME
Equipment etc.
AV Equipment
* VGA cable is not supplied with the display. If you use low quality VGA cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the display via the VGA input.
<Back>
HDMI Cable (Accessory)
Audio Cable (Not Included)
VGA Cable (Not Included)*
RS-232C Cable (Accessory)
DisplayPort Cable
(Accessory)
or
mDP-DP Cable
(Accessory)
BEFORE YOU OPERATE THE DISPLAY 17
Computer
Notebook