Id Remote Control - Iiyama ProLite LE6540UHS-B1 User Manual

ID REMOTE CONTROL

You can set the remote control ID when you want to use the remote control on specific monitors.
ID Mode (To enter ID Mode) : Press and hold the ID button until the red LED blinks twice.
Normal Mode (To leave ID Mode) : Press and hold the Normal button until the green LED blinks
 Programming ID Mode
To assign an ID to a remote control.
1. Enter ID Mode.
2. Press and hold the ID SET button until the red LED turned on.
3. Using the number button, input the desired ID. (01 - 255)
4. Press the ENTER button to confirm ID.
5. The red LED will blink twice when ID has been confirmed.
6. Press the ID SET button will exit the ID Mode. The green LED turned on.
NOTE
• Not pressing any button within 10 seconds will exit the ID Mode.
• If an error pressing of buttons other than the digits occured, wait 1 second after the red LED
lights off and then lights up again, then press the correct digits again.
• To cancel or stop programming an ID, press the ID SET button.
• It is necessary to set up the ID number for each monitor before selecting its ID number.
 Use ID Mode
1. Enter ID Mode.
2. Input the ID of the monitor which would like to control by number button.
3. Press the ENTER button.
twice.
BEFORE YOU OPERATE THE DISPLAY 13