More About Your Advanced Water Filter - Frigidaire Professional FPHS2687KF Use & Care Manual

More about your Advanced Water Filter

The PureSource Ultra
filter system is tested and certified by NSF
International, the nationally respected,
not-for-profit certification organization for
public health safety. The PureSource
Ultra
ice and water filter system is tested and
TM
certified to ANSI/NSF Standards 42 and 53 for the
reduction of claims specified on the performance data
sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may
contain filterable cysts.
Test & certification results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
To replace your PureSource Ultra
filter:
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of
water released during the filter replacement.
1 Turn Off the ice maker power switch.
2 Remove the filter by pushing on the end/face of
the filter.
3 Slide the old water filter cartridge straight out of
the housing and discard it.
4 Unpackage the new filter cartridge. Using the
alignment guide, slide it gently into the filter
housing until it stops against the snap-in connector
at the back of the housing.
5 Push firmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water dispenser
while checking for any leaks at the filter housing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
ice and water
TM
ice and water filter
TM
water
TM
CHANGING THE FILTEr
7 After filling one glass of water, continue flushing
the system for about three minutes.
8 Turn On the ice maker.
9 Press and hold the Filter Status button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from "replace" to
"Good," the status has been reset.
15