Door Removal Instructions - Frigidaire Professional FPHS2687KF Use & Care Manual

Frigidaire professional fphs2687kf: user guide

Hide thumbs Also See for Professional FPHS2687KF:

Service data sheet (2 pages)

Specification sheet (2 pages)

Table of Contents

Top Hinge

Cover Rear

Cover Front

Screw

Top

Hinge

Bottom

Screw

Hinge

Screw

Adjustable Hinge

TO DISCONNECT

1. Press outer ring against face

of fitting

2. Pull to

remove tube

TO CONNECT

Insert tube and

push until mark touches face of fitting

Tools Necessary:

Phillips Head

To prepare for removing the doors:

1 Make sure the electrical power cord is unplugged from the wall outlet.

2 Open both doors and remove the toe grille (as explained in the Installation Instructions

that came with your appliance).

3 Remove any food from the door shelves.

4 Close the doors.

To remove the refrigerator top hinge cover:

1 Remove the three screws from each cover over the top door hinges.

2 Lift hinge cover straight up and off.

To remove the refrigerator door:

1 Trace lightly around the door's top hinge with a pencil. This makes reinstallation easier.

2 Remove the two screws from the top hinge. Lift the door off of the bottom hinge and set it aside.

3 Remove the two bottom hinge screws and hinge if necessary.

To reinstall the refrigerator door, reverse the above steps.

To remove the freezer top hinge cover:

1 Remove the two screws from each cover over the top door hinges.

2 Lift hinge cover straight up and off.

CAUTION

Be sure doors are set aside in a secure position where they cannot fall and cause

personal injury.

To remove the freezer door:

1 Detach the multi-wire cable connector located above the top hinge. Grasp both sides of

the connector firmly and pull apart.

2 Trace lightly around the hinge with a pencil. This makes reinstallation easier.

3 Detach the water tube from the connector located below the freezer door. The connector

releases when you press its outer sleeve inward.

4 Remove the screws from the top hinge and pull the multi-wire cable through it. Lift the

door off of the bottom hinge.

5 Remove the two bottom hinge screws and hinge if necessary.

6 Lay the door on its side to avoid damage to the water tube extending from the bottom hinge.

To reinstall the freezer door, reverse the above steps.