More About Your Advanced Water Filter; Replacing The Water Filter; Ordering Replacement Filters - Frigidaire 242134903 Use & Care Manual

CHANGING THE FILTER
Water Filter
(some models)
The water filter is located at the top right side of the fresh
food compartment.

Replacing the Water Filter

In general, you should change the water filter every six (6)
months to ensure the highest possible water quality. Water
Filter Status on the user interface prompts you to replace
the filter after a standard amount of water (200 gallons/757
liters for PureSource 3
TM
If your refrigerator has not been used for a period of time
(during moving for example), change the filter before
reinstalling the refrigerator.

Ordering Replacement Filters

To order your replacement filters, please visit our online
store at www.frigidaire.com/store, by calling toll-free
at 877-808-4195, or by visiting the dealer where you
purchased your refrigerator. Frigidaire recommends that you
order extra filters when you first install your refrigerator, and
that you replace your filters at least once every six months.
Here is the product number to request when ordering:
PureSource 3 Water Filter
TM
Part #WF3CB

NOTE
When ordering your replacement filter, please reorder
the same filter type that is currently in your refrigerator.
28
) has flowed through the system.

More about your Advanced Water Filter

The PureSource 3
system is tested and certified to NSF/ANSI
Standards 42 and 53 for the reduction of claims
specified on the performance data sheet.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 200 gallons/757 liters for
PureSource 3 ice and water filter
TM
• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per square inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
To replace your PureSource 3
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of water
released during the filter replacement.
1 Turn Off the ice maker power switch.
2 Remove the filter by pushing on the end/face of the
filter.
3 Slide the old water filter cartridge straight out of the
housing and discard it.
4 Unpackage the new filter cartridge. Using the
alignment guide, slide it gently into the filter housing
until it stops against the snap-in connector at the
back of the housing.
5 Push firmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water dispenser
while checking for any leaks at the filter housing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7 After filling one glass of water, continue flushing the
system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from Red to Green, the
status has been reset.
ice and water filter
TM
water filter:
TM