Wan Service - TP-Link TD-W8950N User Manual

TD-W8950N

Note:
The detailed configuration about Scheduler for Queues of Equal Precedence will be described
in Quality of Service.
4.4.1.2 ETH Interface
Choose "Advanced Setup""Layer2 InterfaceETH Interface", you can configure ETH WAN
interfaces on the screen below.

Add: Click the Add button, and you can add a new interface in the next screen.

ETH port: Select an ETH port to configure as the WAN port.
Click Save/Apply to save your settings and then you will see the screen similar to Figure 4-6.

Remove: Select the check box in the table on the screen above and then click the Remove
button, the corresponding interface will be deleted in the table.

Note:
Only one ETH is allowed to configure as the layer 2 WAN Interface.
4.4.2

WAN Service

Choose "Advanced Setup""WAN Service", and you will see the WAN Port Information Table in
the screen similar to Figure 4-7, which describes the WAN port settings and the relevant
manipulation to each interface. After you add a new Lay2 Interface, please follow the instructions
150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-4
Figure 4-5
Figure 4-6
17