Table of Contents
Advertisement
TD-W8950N
8.
On the next screen you will see the WAN Port Information Table with the new configuration.
Remove: Select the check box in the table above and then click Remove, the corresponding
interface will be deleted.
4.4.2.2 ATM-EoA-IPoE
If your ISP provides an IPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1.
Add a new ATM interface
2.
Click the Add button on the screen (as shown Figure 4-7). Select WAN Service Interface over
ATM PVC on the next screen (as shown Figure 4-8).
3.
If your ISP provides an IPoE connection, select IP over Ethernet option for the WAN service
type on the screen (as shown Figure 4-9), and click Next button to continue.
4.
Enter parameters in the following blanks to configure the WAN IP Address and click Next.
150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-13
Figure 4-14
(4.4.1.1 ATM
Interface).
21
Advertisement
Table of Contents
