Step 2 Getting Sound To The Speakers - Yamaha MG12XUK Owner's Manual

Quick Start Guide

STEP 2 Getting sound to the speakers

1.
Make sure that the [
panel is set to the [
2.
Connect the supplied AC adaptor.
q Connect the power adaptor with the gap of the
plug facing up, aligning it to the [AC ADAPTOR
IN] connector.
[AC ADAPTOR IN] connector
w Turn the fastening ring clockwise to secure the
connection.
e Plug the power adaptor into a standard house-
hold power outlet.
3.
Make sure that all switches on the unit are not
engaged (pressed in).
4.
Turn all the level control knobs fully to the left (min-
imum). These include the [GAIN] knobs (white),
[LEVEL] knobs (white), and [STEREO LEVEL] knob
(red).
10
MG12XUK Owner's Manual
/ ] switch at the rear
] position (power off).
[ / ] switch
5.
Set the equalizer knobs (green) to the center ""
position.
4
[GAIN]
5
Equalizer
4
[LEVEL]
6.
If you connect a device with high output level, such
as a CD player or an electric keyboard, to one of the
channels 1 to 6, turn on (
the corresponding channel*.
Channel
[PAD] switch
NOTE
If you are using condenser microphones, turn on (
[PHANTOM +48V] switch.
7.
Make sure that the volume of a powered speaker or
amplifier is set to the minimum.
4
[STEREO
LEVEL]
) the [PAD] switch of
) the