ALLEN & HEATH XB-14-2 User Manual page 37

Cut and solder option
SOLDER BLOB
HERE
NOTE: when cutting
track ensure cut lines
don't extend beyond
marked area
JP4
JP1
Stereo channel jumpers
PGM FADER
BYPASS
Additive mix options
Add a solder bridge to each pair of pads
M1 M2 M3 M4
COMMS
MIC
MIX
Allen & Heath
SERVICE OPTIONS
CUT TRACK
HERE
JP3 JP2
M1 M2 M3 M4
MIC FADER
MUTE
AUX Pre ON switch / Pre fade option
channels)
This is a cut and solder link that sets the action of the AUX pre
switch when it is in the down position.
The default setting is prefade which sources the audio signal after
the ON switch but before the channel fader. The option when mod-
ified sources the signal pre ON switch and post EQ.
Audition fader start option
Cut and solder link. The default for this option is to disable the
channel fader start signal if the audition bus button is depressed. If
the fader start option is required with the audition bus then cut and
re-solder this link.
Stereo channel input option
This option enables the stereo sources for these channels to be
mixed and fed into the channel together. Simply move the position
of all 4 jumpers to their opposing position to enable this option.
The red gain pots can still be used to set relative levels. The green
selection LEDs will both stay on to indicate that both channels are
being mixed. The main channel fader now controls both inputs.
Program fader bypass
By moving the position of these 2 jumpers, the main program fader
will be bypassed. This eliminates the possibility of the program fader
being accidentally pulled down.
CRM / Guest additive mix option
By bridging all eight solder links on the master and meter PCBs re-
spectively, the feed selection buttons on the right hand side of the
mixer are changed from priority mix to additive mix. The default
setting is priority mixing where pressing a button higher up on the
mixer cuts the previous signal to listen to the selected signal.
In additive mixing mode the bottom button still priority switches
between the main program mix and Mix B but all other feeds are
mixed in to the signal when pressed.
Mix B / Rec out solder option
Cut and solder link. Cutting and re-soldering these 2 links changes
the Mix B out phono sockets to provide a pre fader program mix
for recording purposes.
Comms mic mix option
Cutting or adding wire links here determines the source of the mi-
crophone signal that is used to talk to telephone callers and studio
guests with the mixer talk buttons. The signal is sourced after the
channel gain pot and so is not affected by the channel faders. A sin-
gle source or a mix of sources can be used. The default is M1.
Mic fader mute option
Cutting or adding wire links here selects which microphone chan-
nels will mute the control room speakers when a channel fader is
raised and the corresponding ON switch depressed. The default is
that all mic channels will mute the control room feed but any com-
bination can be used.
38
(Mono, Telco and stereo
(Mono and telco channels only)
(channels ST1 - 3 only)
(Mix PCB)
(Master & meter PCBs)
(Distribution PCB)
(Logic PCB)
(Logic PCB)
XB-14 MK2 User Guide