Table of Contents
Advertisement
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, affecting your ears or causing the
speakers to be damaged.
DOLBY DIGITAL (DVD only)
Selects the type of Dolby Digital signal.
D-PCM
Select this when the player is
connected to an audio
component lacking a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
"DOWNMIX" item in
"AUDIO SETUP" (page 68).
DOLBY
Select this when the player is
DIGITAL
connected to an audio
component with a built-in
Dolby Digital decoder.
MPEG (DVD only)
Selects the type of MPEG audio signal.
PCM
Select this when the player is
connected to an audio
component lacking a built-in
MPEG decoder. If you play
MPEG audio sound tracks, the
player outputs stereo signals
via the DIGITAL OUT
(OPTICAL or COAXIAL)
jack.
MPEG
Select this when the player is
connected to an audio
component with a built-in
MPEG decoder.
DTS (DVD only)
Selects whether or not to output DTS signals.
OFF
Select this when the player is
connected to an audio
component lacking a built-in
DTS decoder.
ON
Select this when the player is
connected to an audio
component with a built-in DTS
decoder.
Note
When you use the DIGITAL OUT (OPTICAL or
COAXIAL) jack to listen to MPEG audio signals
and set "MPEG" to "MPEG" in "AUDIO SETUP,"
no sound will come from your speakers if you select
one of the TVS modes.
69
Advertisement
Table of Contents
