No mains power shall be connected to the loudspeakers, doing so will damage the loudspeaker. • This loudspeaker should only be serviced by qualified Apart Audio service personnel. If not, warranty might be void. • Use cables of the right gauge, certainly for long runs.
Page 5
Do not open the loudspeaker or attempt to disassemble the internal parts or modify them in any way. If it should appear to be malfunctioning, discontinue use immediately and have it inspected by qualified Apart Audio service personnel. • Do not expose the loudspeaker to water, damp or wet conditions.
Page 6
When design and technology go hand in hand Kubo is the result of the increasing market demand for stylish and more subtle design audio products. The Apart research & development department was able to create a top-notch product offering amazing sound quality and performance in a discrete and neutral housing.
Page 7
70 V and 100 V compatible (T versions) • End-caps on both sides hide all connections and bracket hardware • Typical brilliant Apart sound • In & link connection with euroblock connectors allows easy daisy chaining of multiple loudspeakers •...
• Connection terminal x 4 Loudspeaker cable is not included. Installation instructions ATTENTION Apart Audio nv is not responsible for damages resulting from the negligent installation of any loudspeaker. WARNING Please make sure that the mounting structure is capable of safely supporting the loudspeaker’s...
Page 9
Instruction manual KUBO3(T) / KUBO5(T) Determine the position where the bracket will be mounted on the wall or ceiling. vertical bracket alignment horizontal bracket alignment Mark two mounting holes on the wall or ceiling and mark the mounting hole in the middle for an invisible installation of the safety cable (see below).
Page 10
Design cabinet loudspeaker If the bracket is to be mounted on stone or concrete, drill the mounting holes (stone drill 6 mm). Attach the bracket using the adequate hardware. For wood use only the screws, for other material use the correct fixing material.
Page 11
Instruction manual KUBO3(T) / KUBO5(T) Mount the bracket on the wall. Connect the loudspeaker cables to the euroblock terminals. The use of wire ferrules is strongly recommended when stranded wire is used.
Page 12
Design cabinet loudspeaker Connect the safety cable to the integrated safety nut. Slide the loudspeaker into the K-Mount.
Page 13
Instruction manual KUBO3(T) / KUBO5(T) Rotate the loudspeaker and connect the euroblock connectors. Tighten the fixing bolts by hand or with a screwdriver if the space between the wall and the loudspeaker is limited.
Page 14
Design cabinet loudspeaker On the 70 / 100 volt versions, set the selector according to the required power rating or connection type. WARNING Set the power tapping prior to applying audio and only change the setting while the audio amplifer is shut off. WARNING The 16 ohm setting is not compatible with 70 volt or 100 volt line amplifiers!
Page 15
Instruction manual KUBO3(T) / KUBO5(T) Finish the installation by mounting the supplied magnetic end caps.
Page 16
Design cabinet loudspeaker Technical drawings - KUBO5(T) inch 6.44 6.10 A - B inch 6.46 7.28 5.34...
Page 24
Apart Audio nv Industriepark Brechtsebaan 8 bus 1 2900 Schoten - Belgium Company names, product names and trademarks are property of their respective owners. Apart Audio specifications are subject to change without notice.
Need help?
Do you have a question about the KUBO3T and is the answer not in the manual?
Questions and answers