Table of Contents
Advertisement
Answering system
Answering system settings
To record a new outgoing announcement:
MENU
1. Press
2. Press
or
CID
SELECT
.
3. Press
SELECT
4. Press
SELECT
announces, "Record after the tone. Press STOP when you
are done."
5. After the tone, speak towards the microphone of the
handset or the telephone base. Press
recording.
6. The newly recorded announcement automatically plays.
Press
STOP
to stop the playback at any time, or
desired.
To listen to the recorded announcement again, wait after playback has
completed, then scroll to Play annc and press SELECT.
Notes:
Your announcement can be up to 90 seconds in length.
f
Announcements shorter than two seconds are not recorded.
f
To delete or reset your outgoing announcement:
MENU
1. Press
2. Press
or
CID
SELECT
3. Press
4. Press
or
CID
prompts Reset to default annc?. Press YES to confirm. The system
announces, "Announcement deleted." and the screen shows Annc. reset to
default before returning to the previous menu.
-OR-
Press
or
CID
announcement. While the announcement is playing, press
a handset or X/DELETE on the telephone base to reset the announcement.
The system announces "Announcement deleted." and the screen shows Annc.
Deleted before returning to the previous menu.
When your announcement is reset, the system answers calls with the default
announcement, as described on page 141. You cannot delete the default
announcement.
in idle mode.
to scroll to Answering sys, then press
DIR
to select Announcement.
again to select Record annc. The system
in idle mode.
to scroll to Answering sys, then press
DIR
again to select Announcement.
to scroll to Reset annc and press SELECT. The screen
DIR
to scroll to Play annc, and then press
DIR
STOP
to end
RECORD
142
Recording
announcement...
STOP
Playing
announcement...
RECORD
STOP
to record again, if
SELECT
.
SELECT
to play the
/DELETE on
MUTE
Advertisement
Table of Contents
