Load The Dk Roll - Brother QL-600B User Manual

Set Up the Label Printer

Load the DK Roll

a
Hold the printer by the front, and firmly lift the DK Roll Compartment Cover to open it.
b
Place the DK Roll into the Roll Spool Guide (1).
• Make sure that the Roll Spool Arm (2) is inserted firmly in the Roll Spool Guide.
• Make sure the Stabiliser (3) slides into the notch of the printer.
c
Thread the DK Roll through the printer.
• Align the edge of the DK Roll with the upright edge of the Label Output Slot.
• Check that the DK Roll is threaded straight so that the labels will not be skewed.
• Push the first label through the Label Output Slot until the end comes out of the Slot as shown.
3
1
2
1
1
5