Connect The Power Cord; Load The Dk Roll - Brother QL-1100 Quick Setup Manual

3. Connect the Power Cord

Connect the AC Power Cord to the printer. Then, plug the AC
Power Cord into an earthed electrical socket.

4. Load the DK Roll

1.
Make sure that the printer is turned Off.
2.
Pull the release levers on both sides of the printer to unlock the DK Roll
Compartment Cover.
Hold the printer by the front, and firmly lift the DK Roll Compartment Cover to
open it.
IMPORTANT IMPORTANT
Before using the printer, remove the protective sheet (1) from the Label Output Slot.
3.
Place the DK Roll into the Roll Spool Guide (1).
• Make sure that the Roll Spool Arm (2) is inserted firmly in the Roll Spool Guide.
• Make sure the Stabiliser (3) slides into the notch of the printer.
1
3
2
1