Table of Contents
Advertisement
Figure 12. Installing the heat sink and fan assembly
6. Connect the new microprocessor fan cable to the system board.
7. Reinstall the removed parts.
Storage drive
Prerequisite
Before you start, read Appendix A "Important safety information" on page 77 and print the following
instructions.
Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
Replacing the 3.5-inch storage drive
1. Remove the computer cover. See "Computer cover" on page 42.
2. Remove the front bezel. See "Front bezel" on page 43.
3. Pivot the drive bay assembly upward. See "Pivot the drive bay assembly upward and downward" on
page 47.
4. Disconnect the signal cable and the power cable from the 3.5-inch storage drive.
5. Refer to the following to replace the 3.5-inch storage drive.
• 3.5-inch primary storage drive
50
User Guide
Advertisement
Table of Contents
