Causes Of Damage; Damage To The Oven; Set-Up, Gas And Electricity Connection; Gas Connection - Siemens HR523213T Instruction Manual

Causes of damage

Hob
Caution!
Only use the burners when cookware has been placed on
■
top. Do not heat up empty pots or pans. The saucepan base
will be damaged.
Only use pots and pans with an even base.
■
Place the pot or pan centrally over the burner. This will
■
optimise transfer of the heat from the burner flame to the pot
or ban base. The handle does not become damaged, and
greater energy savings are guaranteed.
Ensure that the gas burners are clean and dry. The burner
■
cup and ¶burner cap must be positioned exactly.
Ensure that the top cover is not closed when the oven is
■
started up.

Damage to the oven

Caution!
Accessories, foil, greaseproof paper or ovenware on the
■
cooking compartment floor: do not place accessories on the
cooking compartment floor. Do not cover the cooking
compartment floor with any sort of foil or greaseproof paper.
Do not place ovenware on the cooking compartment floor if a
temperature of over 50 ºC has been set. This will cause heat
to accumulate. The baking and roasting times will no longer
be correct and the enamel will be damaged.
Water in a hot cooking compartment: do not pour water into
■
the cooking compartment when it is hot. This will cause

Set-up, gas and electricity connection

Gas connection

If the appliance is set up to use liquefied gas and will be
operated using liquefied gas, establish the gas connection in
accordance with the instructions under "Gas connection and
conversion to a different gas type".
Caution!
The type of gas for this appliance is marked with a star (*) on
■
the identification plate on the rear of the appliance. If the star
symbol appears next to the label "NG", the appliance is set
up for natural gas, and if it appears next to "LPG", the
appliance is set up for liquefied gas.
Before connecting the appliance, check whether the local
■
connection conditions (gas type and pressure) correspond to
the appliance settings.
This appliance is not connected to a waste gas main. It must
■
be connected and commissioned in accordance with the
installation conditions. Do not connect the appliance to a
waste gas main. All ventilation regulations must be observed.
The gas connection must be made via a fixed, i.e. not mobile
■
connection (gas line) or via a safety hose.
If using the safety hose, ensure that the hose is not trapped
■
or crushed. The hose must not come into contact with hot
surfaces.
The connection must have an easily accessible locking
■
device.
If this is the case, please contact our after-sales service:
if the appliance is set up for natural gas (NG) and operated
using natural gas.
if the appliance is set up for natural gas (NG) but is operated
using liquefied gas (LPG).
6
steam. The temperature change can cause damage to the
enamel.
Moist food: do not store moist food in the cooking
■
compartment when it is closed for prolonged periods This will
damage the enamel.
Fruit juice: when baking particularly juicy fruit pies, do not
■
pack the baking tray too generously. Fruit juice dripping from
the baking tray leaves stains that cannot be removed. If
possible, use the deeper universal pan.
Cooling with the appliance door open: only allow the cooking
■
compartment to cool when it is closed. Even if the appliance
door is only open a little, front panels of adjacent units could
be damaged over time.
Very dirty door seal: If the door seal is very dirty, the
■
appliance door will no longer close properly when the
appliance is in use. The fronts of adjacent units could be
damaged.Always keep the door seal clean.
Appliance door as a seat, shelf or worktop: Do not sit on the
■
appliance door, or place or hang anything on it. Do not place
any cookware or accessories on the appliance door.
Inserting accessories: depending on the appliance model,
■
accessories can scratch the door panel when closing the
appliance door. Always insert the accessories into the
cooking compartment as far as they will go.
Carrying the appliance: do not carry or hold the appliance by
■
the door handle. The door handle cannot support the weight
of the appliance and could break.
if the appliance is set up for liquefied gas (LPG) but is operated
using natural gas (NG).
Safety information
The nominal operating pressure of the appliance is;
For natural gas (G20) 20 mBar, for LPG (G30) 30 mBar, for
LPG (G31) 37 mBar. The appliance must be operated at these
pressure values. All data on the rating plate of your appliance
relates to these pressure values. The manufacturer is not
responsible for results, performance or any risk caused by
operating the appliance at different values.
:
If the gas pressure in your gas supply grid!
for natural gas (G20) is higher than 25 mBar, for LPG (G30) is
higher than 36 mBar, for LPG (G31) is higher than 45 mBar,
you must use your appliance in connection with a suitable gas
regulator, for safety reasons. Connection, maintenance and
configuration of the gas regulator must be performed by an
authorised installation expert. If you do not know the gas
pressure in your gas supply grid, please ask your local supply
grid operator.

Faults in the gas installation/smell of gas

If you notice a smell of gas or faults in the gas installation, you
must
immediately shut off the gas supply and/or close the gas
■
cylinder valve
immediately extinguish all naked flames and cigarettes
■
switch off electrical appliances and lights
■
open windows and ventilate the room
■
call the after­sales service or the gas supplier
■