Advertisement
Shipping
13
stabilizer
Blade assembly
Remove shipping stabilizers from motor
assembly.
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
16
Align the labels with an arrow on switch
housing and light fixture, and then attach
the light fixture onto switch housing,
aligning keyhole slots on the light fixture
with the preassembled set screws on
switch housing and twist clockwise until
lock. Reinstall the screw removed in step
14. Tighten all screws securely.
Thread pull chains from fan through the
pull chain guides on light fixture.
© 2011 Monte Carlo Fan Company
14
Loosen 3 and remove 1 preassembled
set screws from switch housing. Save
screw for later use.
17
Label
Pull chain
guide
Label
Install 13W x 2 CFL medium base bulbs.
Bulbs included. WARNING: USE MAXIMU
13 WATTS MEDIUM BASE LISTED
SBCFL(SELF-BALLASTED COMPACT
FLUORESCENT LAMP) ONLY, NOT USING
SBCFL WILL OVERHEAT THE UNIT AND
CAUSE DAMAGE TO THE UNIT OR THE
FAN WHICH THE UNIT IS INSTALLED
TOGETHER.
Caution: Do not replace bulb until it
cools down.
15
Connect white wire from fan to white wire
from light fixture, and then connect blue
wire from fan to black wire from light
fixture.
18
Partially loosen the 3 set screws from
light fixture.
Attach glass onto the light fixture, and
hand tighten the set screws. Do not over
tighten the set screws.
5
11/5/2012
Advertisement
