Advertisement
7
Ground/Green
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
Wiring Option with Wall Controller
10
Power supply
For control of fan and light from wall
location, follow diagram as shown.
Note: A professional electrician is
recommended for this type of installation.
© 2011 Monte Carlo Fan Company
8
Tab
Ground/Green
Lag screw
Safety cable
Slot
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 3" lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
11
Stud
Lift Canopy, allowing the 2 studs to
protrude through the canopy.
Install knurled nuts (knurled nuts
provided) and tighten the knurled nuts
securely. The canopy should adjust for
any irregularity in the ceiling or outlet
box.
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
SAFETY CABLE INSTALLATION
Washer
Lock washer
4
9
Make wire connections as indicated
above. Connect Black and Blue wire from
fan to Black (Hot) wire from house.
Connect White wire from Fan to White
(Neutral) wire from house. Connect all
green grounded wires from fan to
Grounded wire from House. Make sure
that no filaments are outside of the wire
connectors.
12
Blade bracket
Install blade bracket with blade by 3
blade screws and washers provided.
Tighten securely. Repeat this process for
remaining blades.
Wall Switch
White
Power
Black
Line
Grounded/
Green
Black
Blue
White
Blade
11/5/2012
Advertisement
