Preparing The Remote Control; Inserting And Removing Batteries; When Using The Multiple Projectors - Panasonic PT-LW333 Operating Instructions (Functional Manual)

Preparing the remote control

Inserting and Removing batteries

1) Open the cover. (Fig. 1)
2) Insert batteries and close the cover (Insert the "m" side first.). (Fig. 2)
f When removing the batteries, perform the steps in reverse order.

When using the multiple projectors

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector
individually using single remote control, if unique ID number is assigned to each projector.
When you want to set the ID number, at first you need to set the ID number of the projector, and then set the ID number on the
remote control.
The factory default ID number of the unit (the projector and the remote control) is set to [ALL], you can control with this setting.
If necessary, please set the ID number to the remote control and the projector.
About how to set the ID number of the remote control, please refer to "Setting the remote control ID numbers". (x page 45)
Note
f Set the ID number of the projector from the [Expand] menu → [Remote control]. (x page 73)
Chapter 1 Preparation - Preparing the remote control
(ii)
(i)
Fig. 1
Fig. 2
ENGLISH - 25