When Connecting Via Wired Lan - Panasonic PT-LW333 Operating Instructions (Functional Manual)

f Use shielded LAN cable (STP cable) that is compatible with category 5 or above.
f Use a LAN cable with length of 100 m or shorter.
Projector settings
1) Use the LAN cable (Straight) to connect the projector with computer.
2) Turn on the projector.
3) Set the [Expand] menu → [Network] → [Network setting].
f For details, refer to the [Expand] menu → [Network] (x page 72).
Note
f Please confirm with your network administrator before you connect to an existing network.
f The following settings are set before the projector leaves the factory.
Computer setting
Connection can be made with wired LAN. However, confirm to your system administrator on network settings before chang-
ing any settings.
1) Turn on the computer.
2) Make the network setting according to your system administrator.
f If the projector settings are the default settings, the computer can be used with the following network settings.
When connecting via wireless LAN
The wireless module (Model No.: ET-WML100) of the optional accessories is required if you want to use the network function
through the wireless LAN.
f The wireless module can be connected via the wireless LAN to only the projector that the wireless module is attached.
Connection example
Preparation and confirmation of the projector
1) Turn on the projector.
2) Insert the wireless module (Model No.: ET-WML100) of optional accessories firmly into the <USB A
(VIEWER/WIRELESS)> terminal.
Chapter 5 Operation of Function - Network connection
[DHCP]
[IP address]
[Subnet]
[Gateway]
[DNS]
[IP address]
[Subnet]
[Gateway]
IEEE802.11b/g/n
Off
192.168.1.100
255.255.255.0
192.168.1.1
192.168.1.1
192.168.1.101
255.255.255.0
192.168.1.1
Wireless module of optional accessories
(Model No.: ET-WML100)
ENGLISH - 83