Set Id; How To Connect External Control Equipment - LG BX327 Owner's Manual

SET ID

1. Press the MENU button. Then, move to OPTION with the ∧, ∨,
＜, ＞ buttons and press the ◉OK button.
2. Press the ∧, ∨ buttons to move to Set ID and press the ◉OK
button.
3. Press the ＜, ＞ button to select your desired number. Press the
◉OK button to save the selected number.
• The adjustment range of Set ID is 1~99.
• Only the projector with the specified ID number will operate from the
remote control.
• Press the BACK button to exit the menu screen.

How to connect external control equipment

* Connect the serial port of the PC to the RS-232C jack on the projector back panel.
* RS-232C cable is not supplied with the projector.
* Use the RS232C cable to control the projector externally (Refer to Fig.1).
<Fig.1, RS-232 Interface Cable>
RXD
2
TXD
3
DTR
4
GND
5
DSR
6
RTS
7
CTS
8
PC
* 1, 9 Pin No Connection
Communication Parameter Setup
• Baud Rate : 9600bps(UART)
• Data Length : 8bit
• Parity : none
• Stop bit : 1bit
• Flow Control : none
• Communication code : ASCII code
RXD
2
TXD
3
DTR
4
GND
5
DSR
6
RTS
7
CTS
8
Projector
9 6
5 1
OPTION
Menu Language : English
Blank Image : Blue
Screen Capture
Lamp Mode : Normal
Monitor Out : RGB1
Set ID : 1
Network Setting
High Altitude : Off
3D Mode
Function
ꔂMove ꔉOK
31