Installing And Composition; Installation Precautions - LG BX327 Owner's Manual

3d ready dlp projector with a 3d optimiser to support four types of 3d

Hide thumbs Also See for BX327:

Table of Contents

Installing and Composition

Provide proper ventilation for this projector.

• The projector is equipped with ventilation holes(intake) on

the bottom and ventilation holes(exhaust) on the front. Do

not block or place anything near these holes. Internal heat

build-up may occur, causing picture degradation or dam-

age to the projector.

• Never push projector or spill any kind of liquid into the

projector.

Place this projector in adequate temperature and humidity conditions.

• Install this projector only in a location where adequate temperature and humidity is available. (refer page 54)

Don't place the projector where it can be covered with dust.

• This may cause overheating of the projector.

Do not obstruct the slots and openings of the projector. This may cause overheating and create a fire hazard.

This projector is manufactured using high-precision technology. You may, however, see tiny black points and/or bright

points (red, blue or green) that continuously appear on the projector Screen. This is a normal result of the manufacturing

process and does not indicate a malfunction.

To display DTV programs, it is necessary to purchase a DTV receiver (Set-top Box) and connect it to the projector.

The remote control may not work when a lamp equipped with electronic ballast or a three-wavelength lamp is installed.

Replace those lamps with international standard products to use the remote control normally.

ꔈ Do not place the projector on a carpet, rug or other simi-

lar surface. It may prevent a adequate ventilation of the

projector bottom. This product should be mounted to a

wall or ceiling only.

• Leave an adequate distance (30 cm or more) around the

projector.

Table of Contents

Show Quick Links

Table of Contents