Position The Blower Location Template - KitchenAid JES1750FS Installation Instructions Manual

4. Drill two ¹⁄
" (3 mm) holes that correspond to the bracket
8
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
Rear position Front position
Wall Mounting
5. Using the two #10 x 1 ⁄
5
8
provided, mount anti-tip bracket to the wall or floor.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard
or hardboard from under range.
7. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
8. Move range forward onto shipping base, cardboard
or hardboard to continue installing the range, using
the following installation instructions.

Position the Blower Location Template

1. Determine and mark the centerline on the floor of the cabinet
opening.
A. Centerline
Diagonal (2 options)
" (4.1 cm) Phillips-head screws
A
2. Locate the blower location template in the Installation
Parts Kit.
3. If the countertop extends behind the opening, measure
the distance from the back edge of the cabinet cutout
to the wall.
A. Countertop Filler Depth
4. Fold the top of the blower mounting/venting template
on the line that corresponds to the countertop depth
measured in Step 3.
Le montage du ventilateur doit être fait dans cette zone
Le montage du ventilateur doit être fait dans cette zone
RETIRER LE GABARIT AVANT DE FINALISER L'INSTALLATION
GABARIT D'INSTALLATION D'UN SYSTÈME DE VENTILATION À ASPIRATION DESCENDANTE
NOTE: The template has lines every
edge. If the distance measured in the previous step is 1
(32 mm), fold the template on the line labeled 1
If there is no countertop filler depth, fold the template at zero
depth.
A
Fold Here
Fold On Line Based On
Countertop Filler Depth
Measurement
Replier sur la ligne en
fonction de la mesure de
profondeur du bouche-fente
pour comptoir
No Rear
Countertop
Filler Fold Here
Pas de
bouche-fente pour
comptoir arrière pour
replier ici
Part Number W10765779B
© 2015. All rights reserved.
Numéro de la pièce W10765779B
© 2015. Tous droits réservés.
/ " (6.4 mm) from the back
1
4
/ " (32 mm).
1
4
/ "
1
4
13