Remote Control - Sharp HT-SB38 Operation Manual

Remote control

Battery installation
Use 2 "AA" size battery (UM/SUM-3, R6, HP-7 or
similar).
Batteries are not included.
1
Open the battery cover.
2
Insert the batteries according to the direction
indicated in the battery compartment.
When inserting or removing the battery, push them
toward the battery terminals.
3
Close the battery cover.
Caution:
Remove the battery if the sound bar will not be used
for a long period of time. This will prevent potential
damage due to battery leakage.
Do not use rechargeable battery (nickel-cadmium
battery, etc.).
Installing the battery incorrectly may cause the sound
bar to malfunction.
Batteries (battery pack or battery installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
Notes concerning use:
Replace the battery if the operating distance is reduced
or if the operation becomes erratic.
Periodically clean the transmitter on the remote control
and the sensor on the sound bar with a soft cloth.
Exposing the sensor on the sound bar to strong light
may interfere with operation. Change the lighting or the
direction of the sound bar.
Keep the remote control away from moisture, heat,
shock, and vibrations.
Checking the remaining amount of battery level
The battery level is shown by the battery indicator during
operation.
When the battery
When the battery
level is high
level is high
When the battery level is very low, "Battery low" will
appear on the display.
Replace the battery with a new one.
When "Battery low" appears on the display, the power
will be disconnected automatically.
Battery indicator
Battery indicator
When the battery
When the battery
level is very low
level is very low
Notes:
The battery indicator will not correctly display the
remaining capacity for approximately 10 seconds after
the power has been turned on.
The number of bars shown in the battery indicator may
increase or decrease, depending on the operation
being performed. This is normal.
The battery life and the operating time may be
shortened by usage conditions, long periods of disuse,
etc.
Test of the remote control
Point the remote control directly at the remote sensor on
the sound bar.
The remote control can be used within the range
shown below:
8" - 20'
(0.2 m - 6 m)
USB connection
To operate the remote control without battery power,
connect a Micro USB cable (not supplied) to the remote
control power terminal.
Connection of the USB cable to the remote control
disconnect the batteries.
Caution:
The USB connection cannot be used to charge the
remote control or as a media playback.
E-12
Remote
sensor
15° 15°
To source
power