INSTALLATION INSTRUCTIONS
INSTALLATION - VENTED TO THE OUTSIDE
1. INSTALLATION:
Remove the structure from the packa-
ging and remove the 2 screws A to sepa-
ratethe upper part from the lower part
(Fig.1).
- Position hole template on the ceiling
paying attention that the arrow is posi-
tioned on the same side as the appliance
controls (Fig.2).
Make 4, Ø8 holes in the ceiling and drive
in 3 screws without completely tighte-
ning them. Pay attention not to insert
the screw into the hole marked with an
X on the hole template (the screws and
expansion plugs must be suitable for the
type of wall).
- Take the upper part of the structure B
(Fig.3) and insert the 3 slots onto the 3
screws that are not completely tighte-
ned. Rotate slightly to fit (Fig.3). Drive in
the fourth screw X and tighten the remai-
ning 3 to allow definitive blocking of the
upper part ofstructure B.
- Take the lower part of the telescopic
structure C and insert it into the upper
Fig.3
Fig.1
Fig.2
�
- 9 -
�
�
�
�
�