OvervIew This In-CEILING HOUSING is a mounting ADAPTOR that is designed to mount the smart dome camera in built-in style on a double-layer ceiling. whaT’S InCluded HOUSING SAFETY BRACKET (1EA) SAFETY WIRE (1SET) outdoor type (3EA) Lower bracket (exclusively for TEMPLATE (1EA) indoor dome cameras) (1EA) indoor type (2EA) In-ceiling Housing Installation Manual SHD-3000F1 INSTALLATION MANUAL...
InSTallaTIOn InSTruCTIOnS Select an installation position or place that can endure more than 4 times of the total weight of the installation structure. At least 250mm or more of spare height is required above the CEILING BOARD. CEILING BOARD’s thickness should be less than 40mm. Be sure to secure the SAFETY WIRE to avoid a product fall.
Page 5
Fix the ANCHOR BOLT onto the concrete CEILING, and secure the SAFETY WIRE to the ANCHOR BOLT as below: Tighten the nut (“N1”) on the ANCHOR BOLT. ❶ Insert the provided SAFETY BRACKET into the ANCHOR BOLT. Tighten two nuts (“N2”,”N3”) onto the ANCHOR BOLT. Hook and fix one end of the SAFETY WIRE onto the SAFETY BRACKET.
Page 6
InSTallaTIOn (indoor type) Push the HOUSING inside the CEILING through the CEILING hole, and tighten the SCREWs (x2) clockwise to fix the HOUSING on the CEILING. (The BRACKET will be positioned from <A> to <B> as shown.) Ensure that the HOUSING is firmly secured to the CEILING BOARD. BRACKET 브라켓...
Page 7
Insert the bracket where the camera is mounted into the housing and fix it by turning it in the lOCK direction. When the installation is completed, remove both PROTECTIVE TAPE and PRETOECTIVE COVER from the lens. 천장 CEILING HOUSING 하우징 Attach the COver to the hOuSInG.
InSTallaTIOn (outdoor type) Place the TeMPlaTe on the CeIlInG bOard and drill a guided hole. Remove the round filling (“C”) from the TeMPlaTe. ❶ Place the TeMPlaTe A onto the CeIlInG bOard to which you will attach the CEILING mount ADAPTOR and drill a Ø198mm hole. See the figure below for the hole shape.
Page 9
To connect to the camera, insert the external cable through the side hole on the housing to the inside of the housing as shown in the figure. Refer to the installation manual of the camera that you want to install, and prepare necessary cables for camera connection.
Page 10
InSTallaTIOn (outdoor type) As shown in the figure, pull out the protrusions of the rubber cap in the bottom to make a small hole and remove the cable through it to connect to the external cable. Alarm Cable 알람 케이블 Power 전원...
Page 11
Installing the camera Using the three screws, mount the camera in the housing. ※ When attaching the camera to the mount, check the arrow directions in the figure below before proceeding. Remove the dome cover from the camera, and install the cover onto the HOUSING. CEILING 천장...