Table of Contents
Advertisement
1. Connect the power cord to the projector's power inlet. Flip the power cable holder over the plug as
shown.
Note: If you connected the projector using the 100 V power cord, the image brightness is reduced to
approximately 55% of the brightness achievable with the 220 V power cord and the Laser light
flashes orange. For optimal performance, connect the 220 V power cord that came with the
projector. You cannot access the Light Source Mode, Estimated Remains, or Light Source
Calibration menu settings when connected using the 100 V power cord.
2. Plug the power cord into an electrical outlet.
3. Turn on the power switch on the side of the projector.
The projector's On/Standby light flashes briefly and then turns blue. This indicates that the projector
is receiving power.
98
Advertisement
Table of Contents
