Table of Contents
Advertisement
On/Standby
Status
Laser
(power) light
light
light
Off
Flashing
Off
blue
Off
Flashing
Orange
blue
Off
Flashing
Off
blue
Temp light
Filter
Status and solution
light
Orange
Off
Projector is too hot. Wait for about
five minutes so the projector can
switch to standby mode. Then check
the following:
• Make sure that the vents and air
• Clean or replace the air filter.
• Make sure the environmental
• If operating the projector at high
• If the problem persists, unplug the
Off
Off
Laser error.
• Make sure that the vents and air
• Clean or replace the air filter.
• If the problem persists, unplug the
Off
Orange
Low air flow through the projector.
• Make sure that the vents and air
• Clean or replace the air filter.
• If the problem persists, unplug the
250
filter are not clogged with dust or
obstructed by nearby objects.
temperature is not too hot.
altitude, turn on High Altitude
Mode.
projector and contact Epson for
help.
filter are not clogged with dust or
obstructed by nearby objects.
projector and contact Epson for
help.
filter are not clogged with dust or
obstructed by nearby objects.
projector and contact Epson for
help.
Advertisement
Table of Contents
