Table of Contents
Advertisement
• Before you move the projector, make sure its power is turned off, the plug is disconnected from the
outlet, and all cables are disconnected.
• When disposing of the projector, do not disassemble it. Dispose of the projector in accordance with
your local or national laws and regulations.
Laser Safety Information
Laser Safety Labels
Hazard Distance (HD)
Typical Setup Configurations (U.S. Only)
Parent topic:
Laser Safety Information
This projector is a Class 1/RG3 laser product that complies with the IEC60825-1 international standard
for lasers. This projector contains a high-powered laser component and the following precautions should
be taken when operating the projector to avoid injury or damage:
• Do not enter the exclusion zone that is determined by the light beam Hazard Distance (HD). See the
link below for hazard distance information.
• Never open any covers on the projector except as specifically explained in this manual. Never attempt
to disassemble or modify the projector.
• All installations and repairs of this projector must be done by a licensed service personnel.
• The projector generates high amounts of heat. Do not place flammable or combustible objects around
the projector, especially in front of the lens.
Note: See the link below for additional safety laser cautions and other general safety instructions.
Parent topic:
Related references
Laser Safety Labels
Hazard Distance (HD)
Typical Setup Configurations (U.S. Only)
Laser Safety Labels
Labels are attached to the projector to indicate the level of risk when operating or servicing the projector.
Notices
Important Safety Instructions
289
Advertisement
Table of Contents
