c.
Repeat step a and step b to the opposite side of the chassis.
Figure 2-3
Attaching a Chassis Disk to the Chassis
4.
Attach rear brackets to the rear posts as shown in Figure
a.
Attach a nut bar (B) on the inside of the two rear rack posts using screws (A). Do not
completely tighten the screws, leave them loose enough to allow insertion of the brackets
in step b.
b. Insert the slotted foot of a rear bracket (C) between each nut bar and post.
c.
Align the face of the bracket foot with the edge of the rack post and firmly tighten the
screws.
Figure 2-4
Attaching a Rear Bracket to a Rear Post
A. Chassis disk
B. #6-32 x 3/16-inch screw
2‐4.
C
B
A. #10-32 x 1/2-inch screw
B. Nut bar
C. Rear bracket
RBT-8100 Wireless Switch Installation Guide 2-3
Mounting in a Four-Post System
A
B
A