FLIR LOREX NR810 Series Instruction Manual page 85

13 Using the Main Menu
4. Click Set next to Region to configure which areas of the image will be enabled for mo-
tion detection. The camera image appears with a red grid overlay on the entire image,
letting you know that motion detection is active for the entire image. Click or click-and-
drag to add/remove area from the red grid.
Motion Grid
• Hover the mouse at the top of the screen to select which motion zone you would like
to configure. You can set up to 4 motion detection zones and customize the sensitiv-
ity and threshold for motion detection separately for each zone between 0 (lowest)
and 100 (highest).
• The Sensitivity level determines how sensitive the camera is to motion. For exam-
ple, if the sensitivity is high, small amounts of motion are more likely to trigger an
event. It is recommended to select a sensitivity level between 30~70.
• The Threshold level determines how much motion is required to trigger an event. If
the amount of motion exceeds the threshold, an event occurs. It is recommended to
select a Threshold level between 10~50.
• Right-click when finished.
NOTE
It is recommended to have a second person walk in front of the camera to test different sensitivity
and threshold settings to determine the best setting for your camera's location.
5. To configure a schedule when motion detection will be enabled on this channel, click
Set next to Period. Configure times when motion detection will be enabled. For exam-
ple, you may want to disable motion detection during business hours and enable it out-
side of business hours. Click OK when finished.
NOTE
This setting can override scheduled motion recording. This means that motion recording will only
take place at times that are enabled both in the Schedule menu and here.
#LX400094; r.43927/43955; en-US
75