TP-Link Auranet EAP115-Wall User Manual page 13

SSID Name:
Wireless
VLAN ID:
SSID
Broadcast:
Security
Mode:
Portal:
SSID
Isolation:
Modify:
Following is the detailed introduction of security mode: WEP, WPA-Enterprise and
WPA-PSK.
WEP

WEP (Wired Equivalent Privacy), based on the IEEE 802.11 standard, is less safe than
WPA-Enterprise or WPA-PSK.
NOTE:
WEP is not supported in 802.11n mode. If WEP is applied in 802.11n mode, the clients may
not be able to access the wireless network. If WEP is applied in 11b/g/n mode, the device
may work at a low transmission rate.
Enter up to 32 characters as the SSID name.
Set a VLAN ID (ranges from 0 to 4094) for the wireless network. Wireless
networks with the same VLAN ID are grouped to a VLAN.
Enable this function, AP will broadcast its SSID to hosts in the surrounding
environment, as thus hosts can find the wireless network identified by this
SSID. If SSID Broadcast is not enabled, hosts must enter the AP's SSID
manually to connect to this AP.
Select the security mode of the wireless network. For the security of
wireless network, you are suggested to encrypt your wireless network. This
device provides three security modes: WPA-Enterprise, WPA-PSK (WPA
Pre-Shared Key) and WEP (Wired Equivalent Privacy). WPA-PSK is
recommended. Settings vary in different security modes as the details are
in the following introduction. Select None and the hosts can access the
wireless network without password.
Portal provides authentication service for the clients who want to access
the wireless local area network. For more information, refer to
After Portal is enabled, the configurations in
After enabling SSID Isolation, the devices connected in the same SSID
cannot communicate with each other.
Click to open the page to edit the parameters of SSID.
Click to delete the SSID.
5.2 Portal
10
5.2 Portal.
will be applied.