Table of Contents
Advertisement
Specifications
I Matrix Switcher WJ-SX650 Series
Power Source:
Power Consumption:
Ambient Operating Temperature:
Ambient Operating Humidity:
Video Input Board:
Camera Input (CAMERA IN 1 to 32):
Video Output (VIDEO OUT 1 to 4):
Alarm Input (ALARM IN):
RS-485 (Camera) Port:
Extension Port (EXTENSION IN 2, 3):
Video Output Board:
Monitor Output (MONITOR OUT 1 to 16): 1 V [P-P]/75 Ω (BNC x 16)
Data Port (DATA 1 to 4)
DATA 1:
DATA 2:
DATA 3, 4:
Alarm Output (ALARM OUT 1, 2)
Alarm Output:
Alarm Recover Output:
Time Adjust Input*
Time Adjust Output*
Extension Port (EXTENSION 1 IN, OUT)*
3
VS Input*
:
3
VS Output*
:
3
Serial Port*
:
Expansion slot:
RS-485 (Camera) Port*
Functions:
Dimensions:
Weight:
1
*
In the constant operation
2
*
When this unit is powered off, this signal will not be output even with the acceptation of video input signal.
3
*
Not available when the MODE switches are set as Video Output Board 2
4
*
Available only when Video Input Board WJ-PB65C32 is mounted
96
220 V to 240 V AC, 50 Hz
60 W
–10 °C to +50 °C {14 °F to 122 °F}*
Less than 90 %
x 1
1 V [P-P]/75 Ω (BNC x 32), composite video signal
0.5 V [P-P]/75 Ω data signal and 2.5 V [P-P]/75 Ω vertical timing pulse multi-
plexed
1 V [P-P]/75 Ω (25-pin D-sub connector x 4)*
N.O. (Normally Open contact) or N.C. (Normally Close contact) selectable x 32
(37-pin D-sub connector)
6-conductor modular jack x 4 (2-wire or 4-wire communication, with termination
switches (MODE 1 to 4))
37-pin D-sub connector x 2
x 1
Terminal Mode (TMNL) (PS·Data Mode (PS·DATA) selectable*
Terminal Mode (TMNL)
Terminal Mode (TMNL)/Digital disk recorder (HDR) selectable
6-conductor modular jack x 4 (With termination switches (MODE 1 to 4))
Open collector output x 32, Max. 24 V DC, 100 mA
Non-voltage make contact input x 16
3
:
Non-voltage make contact input x 1
3
:
Open collector output x 1, Max. 24 V DC, 100 mA
3
: 6-conductor modular jack x 2 (With a termination switch (TERM: ON, OFF))
1 V [P-P]/75 Ω (VS IN)
(VS OUT (THRU)): VS loop-thru output
(VS OUT): 1 V [P-P]/75 Ω (VS)
9-pin D-sub connector x 2
x 1
4
:
6-conductor modular jack x 4 (2-wire or 4-wire communication, with termination
switches (MODE 1 to 4))
Monitor control (Camera selection, tour sequence, group sequence, group pre-
set, OSD display)
Camera/Receiver control (Coaxial/RS-485 communication)
Recorder control
Alarm control (Alarm event, Alarm ACK, Alarm reset, Alarm suspension, Alarm
History Display)
Timer event, Camera event
420 mm (W) X 265 mm (H) X 372 mm (D)
{16-9/16" (W) X 10-2/5" (H) X 14-3/5" (D)} (excluding rubber feet and projections)
19.0 kg {42 lbs.}
1
2
, active loop-thru output
3
)
Advertisement
Table of Contents
