Dürkopp Adler 1130i-5 Instructions For Service Manual page 16

5
2
1
2 8
www.promelectroavtomat.ru
3.5.2.8 Setting the control knob
(including the stitch length limitation)
The control knob (1) is to be set up in such a way that, when
turning it in counterclockwise sense up to the stop, the
maximum stitch length valid for the given sewing category is
attained (cat. 1: 3 mm, cat 2: 5 mm, cat. 3 and 4: 7 mm). The
scale of the control knob is to be oriented in such a position,
so that the scale end corresponds to the maximum stitch
length, excepting the first sewing category, where the stitch
4
length of the indicator is 3 mm.
Caution! Danger of injury
3
Switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Screw in the screw of the control knob in such a way, that
the spherical surface of the screw (3) bears on the seat of
the cam (4).
- Loosen the screw (5) and turn the control knob in the
clockwise direction, until the pin (6) of the knob (1) bears
1
on the pin (7). Tighten firmly the screws (5).
- Turn the knob in the counterclockwise direction up to the
stop, when the pin (6) of the knob (1) bears on the pin (7)
5 /from the other side/.
- In a sewing test check up the length of the stitch, if this
corresponds to the maximum stitch length valid for the given
sewing category.
- If the stitch is longer, loosen then the screws (5) and turn
the knob in the clockwise direction and inversely. Tighten
7
firmly the screws (5).
- Insert a screwdriver into the hole (8) of the scale (2) and
6
adjust the scale in such a way that the maximum length on
the scale is against the marking of the stitch length on the
machine arm.
- For the sewing category 1, set the control knob (1) on the
stitch length of 3 mm and check it by a sewing test.
- Loosen the screws (5) and turn the control knob (1) in the
counterclockwise direction, until the pin (6) of the knob (1)
bears on the pin (7). Tighten firmly the screws (5).
- Put a screwdriver into the hole (8) of the scale (2) and adjust
the scale in such a way that the value of the stitch length on
the scale against the marking on the arm is 3 mm.
13