Table of Contents
Advertisement
1
3
9
0
o
4
2
4
1
3
2
6 7 8
3
2
www.promelectroavtomat.ru
3.5.2.5 Feeder replacement
The bottom feeder replacement (change of the stitching
category according to the machine setting - see table 11.2 –
machine setting – feeder).
Caution! Danger of injury
Switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Unscrew the screws (1) and remove the throat plate.
- Unscrew the screws (3) and remove the feeder (4) from its
holder.
- Put on the feeder (4) and screw in the screws (3).
- Put on the throat plate (2) as instructed in par. 3.3.2 and
tighten the screws (1).
- Check the height of the feeder teeth and the lateral play of
the feeder, and correct it in case of need as instructed in par.
3.5.2.3 a 3.5.2 4.
3.5.2.6 Forward and rearward stitch length
distribution (rough)
The cam (1) is to be set at the respective angle in such a way
that the stirrup (6) is oriented in such a position, so that the
connecting rods (7 and 8) are in a line with a thoroughly
screwed in knob (9) and with turning the handwheel at 0°.
This setting can be done only after having set the top eccentric
according to the paragraph 3.5.2.1.
Caution! Danger of injury!
Switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Set the zero stitch /screw in the knob (9) to the bottom of
the cam (1)/.
- Set the angle 0° on the handwheel and lock it with the screw
(4).
- Turn the screw (3) in the respective sense in such a way that
the connecting rods (7 and 8) are in a line and tighten the
screw (2).
3.5.2.7 Forward and rearward stitch length
distribution (fine)
When setting the maximum length of the stitch, the forward
and the rearward stitch length must be equal with the
maximum error of ± 5 %.
having set the bottom feeding /par. 3.5.2/.
Caution! Danger of injury!
switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Set the maximum stitch length .
- Place a suitable material under the presser foot and mark
therein the forward and the rearward stitch length.
- With an unequal length of the stitch, proceed to the cor-
rection of setting by turning the screws (2 and 3). When
tightening the screw (3), the forward length of the stitch is
shortened and inversely. When tightening the screw (2), the
forward stitch length is lenghtened.
- Loosen always one screw and tighten thereafter the other
one.
12
This setting is only feasible after
Advertisement
Table of Contents
