Philips GC4845/15 User Manual page 20

ENGLISH
20
Problem
The iron
is plugged
in, but the
soleplate is
cold.
The iron
does not
produce any
steam.
The iron
does not
produce a
steam boost.
Possible cause
There is a
connection
problem.
The temperature
dial is set to MIN.
There is not
enough water in
the water tank.
The steam control
is set to position 0.
The iron is not hot
enough and/or the
drip-stop function
has been activated.
You have used
the steam boost
function too often
within a very short
period.
Solution
Check the mains cord, the plug
and the wall socket.
Set the temperature dial to the
required position.
Fill the water tank (see chapter
'Preparing for use', section 'Filling
the water tank').
Set the steam control to a
position between 1 and 6 (see
chapter 'Using the appliance',
section 'Steam ironing').
Set an ironing temperature that
is suitable for steam ironing ( 2
to MAX). Put the iron on its heel
and wait until the temperature
light has gone out before you
start ironing.
Continue ironing in horizontal
position and wait a while before
you use the steam boost function
again.