ATEN KN2116VA User Manual page 204

Kvm over ip switch
Hide thumbs Also See for KN2116VA:
Table of Contents

Advertisement

KVM over IP Switch User Manual
 Adding Filters
To add an IP filter, do the following:
1. Click Add. A dialog box similar to the one below appears:
2. Specify whether you are filtering an IPv4 or IPv6 address.
3. Key the address you want to filter in the From: field.
 To filter a single IP address, click to put a check in the Single IP
checkbox.
 To filter a continuous range of addresses, key in the end number of
the range in the To: field.
Note: This description is for the AP GUI. The Browser GUI differs as
follows:
1. It doesn't offer an IPv4 or IPv6 choice. It only has From and
To fields for IPv4 filtering.
2. It doesn't have a checkbox to specify a single IP address. To
filter a single IPv4 address, key the same address in both the
From and To fields.
4. After filling in the address, click OK.
5. Repeat these steps for any additional IP addresses you want to filter.
188

Advertisement

Table of Contents
loading

Table of Contents