Electro-Voice R300-L User Manual page 8

deTailed coMponent descriptions
02
2.1 | receiver setup & Operation
1. P lace the receiver and antennas where there is a clear line of sight to the area where the transmitter
will be used. Rotate the antennas to separate them by 90 degrees.
2. install the appropriate power connection blades into the power supply and connect the
power supply cord to the receiver. Plug the power supply into an AC outlet. Push the power
button to turn the receiver on and confirm that it is on by checking the main display screen.
ANTENNA B
3. Manual channel change
a. T he and buttons allow you to scroll through the Channels. When the Channel
you desire is displayed, stop scrolling.
b. After 2 seconds the displayed channel number will start to flash.
c. The number will stop flashing and the new channel is installed.
d. T urn on the transmitter and hold the EZsync port facing the receiver EZSync port,
about a foot (50 cm) away.
8
-10dB 0dB
MIN MAX
LEVEL
VOLUME
BALANCED OUT UNBALANCED OUT 12V .500mA ANTENNA A