Electro-Voice R300-L User Manual page 16

deTailed coMponent descriptions
02
2.2 | Handheld Transmitter setup & Operation
1. insert batteries.
a. Remove the battery compartment cover by unscrewing it completely.
b. I nsert two AA batteries as shown, sliding one up into the housing to make room for
the other.
2. Turn the unit on by pressing and holding the on/off button for 3 seconds, and the display will light up.
3. If a new channel is desired, use EZsync as in Section 2.1 and close battery compartment.
4. Verify reception.
a . W ith the transmitter and receiver on a matching Channel, the main receiver display
should be indicating a RF signal on the bar graph.
b. S peak into the microphone and the Audio Meter bar graph should indicate audio
signal presence.
c. I f the level meters do not show reception, make sure the channels are matching and
refer to the trouble shooting section.
16