Electro-Voice R300-L User Manual page 19

2.3.1 | bodypack Transmitter setup & Operation
1. insert batteries
a. O pen the battery compartment by pressing in on the latch and sliding the door down.
b. Insert two AA batteries with + and – as indicated.
c. Close the battery door by pushing up.
2. T urn the unit on by pressing and holding the on/off button for 3 seconds, and the LCD display will light up.
If channel has not been set, set channel according to 2.1.
3. Microphone/Guitar Operation.
a. For Lapel Microphones the gain switch should be in the LAV position.
b. For Headworn Microphones and Guitar operation the gain switch should be in the INS position.
c. I f lapel microphones are too sensitive and the audio meter on the receiver is reaching the peak,
put the gain switch in INS to lower the gain.
4. Mute Function – press and hold on/off button for 2 seconds until MUTE appears in the LCD Display,
between the Channel and Frequency. The LED above the display will turn red and the sound is muted.
Repeat to turn mute off.
19